Maestro Pedicure Chair
With the Maestro pedicure chair, you are proving to all of your customers that luxury is at the heart of your salon. Requiring only minimal effort, each customer can relax and adjust the seat’s positioning with the built-in control panel while your workers get on with the pedicure.
A pipeless magnetic jet system is in place to not only massage their feet but do so without spreading bacteria. Below the hand-sewn leather cover is a massage system that also comes with heating pads too. Sometimes a warm foot bath isn’t enough and when the cold hits, turn on the heated seats!
Overall Dimensions: 70.4” L (179 cm) x 36.2” W (92 cm) x 55” H (140 cm) – Refer to Installation Drawings for additional details.
Dimensions Seat to Floor: 25” (64 cm)
Shipping Dimensions (Carton Size): 84” L (214 cm) x 40” W (102 cm) x 61” H (155 cm) – The Maestro ships fully assembled.
Shipping Weight: 375 lbs. (190 kg)
Net Weight: 310 lbs. (141 kg)
Client Weight Capacity: 300 lbs. (136 kg)
Basin Capacity: 5.9 US Gallons (22.3 liters)
Power Requirements: 120V AC, 15 Amp, 60HZ. A separate and dedicated 15 Amp GFCI protected circuit MUST be used for each foot spa.
Construction: Welded steel frame with veneered wood panels or Formica® laminate; completely sealed to prevent delamination. ABS cover panels.
Basin: Solid surface, pre-plumbed.
Jet System: Two (2) standard NoPipe™ Dual Stream Magnetic Jets; I-Fill® System (automatically fills and shuts-off) is standard.
Incoming: Hot/Cold supply lines required (1/2” ID) solenoid controlled, built-in fill sensor. Connections located on back of spa base or as
Sprayer/Filler: Inline back-flow prevention is provided.
Discharge: Gravity drain or optional factory install drain pump. If factory installed drain pump is utilized, built-in back-flow prevention is
provided. Two drain pump sizes available: Standard = 8’Head, High Capacity (optional) = 16’Head
MASSAGE: Rolling and kneading massage, full-back, upper-back or lower-back.
CHAIR CONTROLS: Technician’s keypad: Seat Forward/Backward, Tilt and Exit. Electronically controlled, low voltage.
ARMCHAIR: Left Side: Seat Forward/Backward, Tilt and Exit. Electronically controlled, low voltage.
Right Side: Handheld Massage Control Wand.
Chair Release Lever: Manual operation, locks and unlocks chair to allow swivel.
Certification: Underwriters Laboratories Listed Compliance Listings to the following Standards: UL 1951, CAN/CSA C22.2 No. 68-92,
ANSI/ASME A112.18.3M, A112.19.7M, A112.18.1, CSA B125.1.2005
Compliant with IAPMO Plumbing Standards. Fixtures and hoses are UPC compliant.